PRO-POINT 8344129 Manuel D'utilisateur page 15

8344129
troUBLe SHootinG
The following form lists the common operating system with
problem and solutions. Please read the from carefully and follow it.
WarninG: if any of the following symptoms appears during your
operating. Stop using the tool immediately, or serious personal
injury could result. only a qualified persons or an authorized
service center can perform repairs or replacement of tool.
Disconnect tool from air supply before attempting repair or
adjustment. When replacing O-rings or Cylinder lubricate with air
tool oil before assembly.
problem(s)
Tool runs at
normal speed
but loses
power under
load.
Tool runs
slowly.
Air flows
slightly from
exhaust.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
Reciprocating Air Saw
possible
cause(s)
Motor parts
worn.
Motor parts
jammed with
dirt particles.
Air flow
blocked by dirt.
Suggested solution(s)
• H ave a qualified technician
replace worn parts.
• C heck air inlet filter for
blockage.
• P our air tool lubricating
oil into air inlet as per
instructions.
• O perate tool in short bursts
quickly reversing rotation
back and forth where
applicable.
• R epeat above as needed.
If this fails return to service
center.
V 3.0
15