PRO-POINT 8344129 Manuel D'utilisateur page 13

8344129
addinG or cHanGinG BLadeS
Warning! always disconnect the Saw from the air source before
adding or changing blades. after disconnecting the Saw from
the air compressor, there could still be enough air pressure to
activate the Saw. always position the Saw safely and activate the
throttle Lever repeatedly to make sure all of the air is expended.
1. The Blade Guard may be removed when replacing blades,
but it must always be on during operation. Using the Saw
without the Blade Guard can result in severe injury. To
remove the Blade Guard, loosen and remove the two Set
Screws. When replacing the Blade Guard, place it in the slots
and tighten the Set Screws.
2. To change blades, first remove the Chuck Cover by removing
the Screw. Swing the Chuck Cover back on its hinge.
3. Loosen the two Set Screws inside, until the blade can be
removed. Replace with a new blade and tighten the Set
Screws. Replace the Chuck Cover and carefully tighten the
Screw. Do not overtighten the Screw or you may break the
plastic Chuck Cover.
note: Never use a dull, bent, or cracked blade. Check that the
blade and blade guard are tight before each use.
Maintenance
WarninG: disconnect tool from air supply before changing
accessories, servicing or performing maintenance. replace or
repair damaged parts. Use genuine parts only. non-authorized
parts may be dangerous.
1. Lubricate the reciprocating air saw daily with a few drops of
air tool oil dripped into the air inlet.
2. Clean the tool after use. Do NOT use worn, or
damaged blades.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
Reciprocating Air Saw V 3.0
13