PRO-POINT 8344129 Manuel D'utilisateur page 12

V 3.0
operation
cUttinG
• Use a sharp blade especially designed to cut the material you
are working with.
• It is recommended you use a cutting fluid on the metal
surface to avoid heat build up.
• When cutting metallic material with this tool, be sure to use a
fine tooth blade.
• To ensure safe operation adjust the motor speed to a slower
setting by adjusting the variable speed dial to the lower end
of the speed range.
1. Before starting the cut, clearly mark the line of cut.
2. Install the correct blade for the material being cut. Adjust the
speed of the blade as necessary.
note: In general, coarser blades are for wood, plastics, and
composites, and finer blades are for cutting metal. Cracking,
shattering or vibrations may indicate you need a finer blade or
higher speed. If the blade overheats or clogs, it may indicate you
need a coarser blade or slower speed setting. Replace blades
when they become dull. Dull blades will produce poor results and
may overheat the saw.
3. Connect the tool to it's power source and turn it on.
4. Allow the saw to reach maximum speed.
5. Set the shoe against the workpiece.
6. Start cutting the material. Do not force it. Use only enough
pressure to keep the saw cutting.
7. When finished, turn off the tool.
12
All manuals and user guides at all-guides.com
Reciprocating Air Saw
For technical questions call 1-800-665-8685
8344129