LGB 24265 Manuel page 10

Multi-Train System
The model is equipped with a factory-installed onboard de-
coder for the LGB Multi-Train System. It can be used without
modifications on analog or digital layouts. For operation
with the Multi-Train System, the model is programmed to
loco address 03. For information on programming the loco
address, see the instructions for various MTS components.
If programming results in unsatisfactory operation, you can
reprogram the factory pre-set values of most important CVs:
Program register CV 55 to function value 55. To reprogram
the factory pre-set function values with the 55015, select
programming mode "P" (displays shows "P --"). Then input
6, 5, and 5 and press the right arrow button. The display
shows "P --" again: Input 5, 5, and 5 and press the right
arrow button again.
SERVICE
Lubrication
The axle bearings and the side rod ends should be lubrica-
ted occasionally with a small amount of Märklin Oil (7149).
Replacing the light bulbs
Front lanterns and upper rear lantern: Pull the lantern
housing away from the model. Pull the plugin bulb out of the
socket. Plug in a new bulb. Reassemble.
Lower rear lanterns: Remove the ring around the lantern
lens. Remove the lens. Pull the plug-in bulb out of the socket.
Plug a new bulb into the socket. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the smoke generator
• Pull the safety cover out of the smoke stack (Fig. 4).
• Use pliers or tweezers to pull the old smoke generator out
of the stack (Fig. 5).
• Cut the wires to the old generator and attach them to the
replacement generator.
• Insulate the connections and push the replacement
generator into the stack (Fig. 6).
• Reassemble.
Replacing the traction tire
• Remove the rod guards located between the first and
second axles.
• Remove the hex head screws joining the drive rods to the
connecting rods on the third axle.
• Counting from the front, remove the second and fifth
screws on the bottom of the gearbox.
• Remove the gearbox from the chassis. Disconnect the
wiring cable.
• Use a small, straight-blade screwdriver to pry the old
traction tire out of the wheel groove.
• Use a small, straight-blade screwdriver to gently pry the
new traction tire into the wheel groove.
• Make sure that the traction tire is seated properly in the
wheel groove.
• Reassemble.
9