Electrical Connection - FUST NOVAMATIC KS 75.3-IB Notice D'utilisation

All manuals and user guides at all-guides.com
2
1
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natu-
ral fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the re-
versibility of the doors at your cost.

Electrical connection

Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
1
2
3
• Remove the screw fixing the lower door
hinge and the other screw fixing the low-
er door hinge and the foot. Then remove
the door hinge and the foot as shown in
the figure.
• Loosen the screw fixing the foot opposite
the lower door hinge in order to remove
the foot.
• Fix the door hinge and the correspond-
ing foot on the opposite side and then
the other loosened foot at the former
place of the door hinge as shown in the
figure.
• Make sure to place the lower foot below
the door hinge. The lower foot is recog-
nizable by its 4 ribs on the outer surface.
• Fix the door onto the lower hinge pin.
• To fit top door hinge, remove the plastic
blanking plugs carefully, and refit them in
the holes left by the hinge retaining
screws.
• Refit the top hinge using the 2 retaining
screws, taking care that the edge of the
door is parallel with side of the cabinet.
• Replace the hinge cover.
• Relocate the handle and the plastic plugs
to the opposite side.
• Level the appliance, wait for at least four
hours and then connect it to the power
socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
41