Learn To Ride - Segway eMoped C80 Mode D'emploi

7. Learn to Ride

WARNING
Always wear a helmet and other protective gear to minimize any possible injury in the learning process.
Always abide by local laws and traffic rules.
Power on
The vehicle can be powered on in one of the following ways:
Tap the NFC card on the dashboard. You will
hear a beep when the vehicle is powered on
successfully.
11
Enable the AirLock in the App. The vehicle will
power on when you sit on the saddle, or press
and hold the custom button.
Riding
Kick up the kickstand, sit down on the saddle and support yourself with both feet. Gently turn the throttle
inward to start your trip.
NOTE:
Before the rider is seated, the status rings are orange and the throttle cannot be started.
If the rider leaves the seat during riding, an alarm will start, and the throttle will not work.
Locking
Release the throttle and hold the front and rear brake levers with appropriate
force. After the vehicle has stopped, support it with the kickstand.
You can lock your Segway eMoped C80 in the following ways:
Auto lock
Enable the 'Auto lock' feature in the App. When you walk away with the phone,
the vehicle will lock automatically.
Press and hold the custom button.
Tap the NFC card.
NOTE:
After locking, please turn the handlebar to its left end
to ensure that the Handlebar Lock is activated.
The control switch of the Handlebar Lock is located
inside the trunk. You can operate the switch to
enable/disable the lock.
Anti-theft Alarm
After Segway eMoped C80 is locked, if there is abnormal
movement, the status rings will flash in red and green
and a continuous alarm will start.
12