Installation Instructions; General; Electrical Connection - Pelgrim GK410 Notice D'utilisation

installation instructions

54

General

The fitting of the appliance should only be carried out by a registered Corgi
gas fitter.
Please note:
This appliance is not connected to a flue duct. Take care to ensure that there

is sufficient ventilation.
Do not install a hob next to a high cupboard or wall made of flammable

material. (If there is no alternative, ensure that there is a minimal distance of
100 mm between the outer edge of the hob and the wall in question.
Also ensure that there is a minimum distance of 650 mm between the hob
and any overhead extractor fan which may be installed.)
Electrical connection (solely for appliances with a
spark switch)
Electrical connection: 230 V - 50 Hz.
This appliance complies the regulations concerning electromagnetic
compatibility in directive 89/336/EEC.
The electrical connection must comply with national and local regulations.

Wall socket and plug must be accessible at all times.

If you want to make a fixed connection, ensure that a multi-pole switch with a

distance between contacts of 3 mm is installed in the supply cable.
Please note:
This appliance must be earthed.

If the connection cable becomes damaged, it should be replaced by

the manufacturer's service department or by a person with equivalent
qualifications, in order to prevent dangerous situations from arising.