Battery Charging - Nilfisk 9084310010 Instructions D'utilisation

revised 03/2018

BATTERY CHARGING

NOTE
Charge the batteries when the yellow (74) or red LED
(73) turns on, or at the end of each working cycle.
Keeping the batteries charged make their life last
longer.
WARNING!
When the batteries are discharged, charge them
as soon as possible, as that condition makes
their life shorter.
Check for battery charge at least once a week.
WARNING!
If the machine is equipped with lead (WET)
batteries, battery charging produces highly
explosive hydrogen gas. Charge the batteries
in well-ventilated areas and away from naked
flames.
Do not smoke while charging the batteries.
While charging the batteries always keep the
hood open.
WARNING!
Pay careful attention when charging WET
batteries as there may be battery fluid leakages.
The battery fluid is corrosive. If it comes in
contact with skin or eyes, rinse thoroughly with
water and consult a physician.
1. Drive the machine to the appointed recharging area and
engage the parking brake.
2. Turn the ignition key (72) to "0".
3. Open the hood (7).
4. (For WET batteries only) check the level of electrolyte
inside the batteries. If necessary, top up through the caps
(45).
Then leave all the caps (45) open for battery charging. If
necessary, clean the upper surface of the batteries.
5. Charge the batteries according to one of the following
methods, depending on the presence of the electronic
battery charger (47) (optional).
04/2009
INSTRUCTIONS FOR USE
Charging the batteries with an external battery
charger
CAUTION!
Use a battery charger suitable for the type
of batteries installed, refer to the equipment
instructions.
The battery charger voltage rating is 24 V.
1. Disconnect the battery connector (46), which is fitted with a
handle, and connect it to the external battery charger.
2. Connect the battery charger to the electrical mains.
3. After charging, disconnect the battery charger from the
electrical mains and from the battery connector (46).
4. (For WET batteries only) check the level of electrolyte
inside the batteries; then close all the caps (45).
5. Reconnect the battery connector (46) to the machine
connector.
6. Close the hood (7). Now the machine is ready to be used.
WARNING!
Never connect the battery charger to the
opposing part of the connector fixed to the
machine. The electronic system could be
irreparably damaged.
Charging the batteries with the battery charger
(optional)
1. (For WET batteries only) check the level of electrolyte
inside the batteries. If necessary, top up through the caps
(45).
Then leave all the caps (45) open for battery charging.
When the correct level is reached, clean, if necessary, the
upper surface of the batteries.
2. Connect the battery charger cable (48) to the electrical
mains.
WARNING!
Check that the voltage and frequency shown on
the machine serial number plate (37) match the
electrical mains values.
NOTE
When the battery charger is connected to the
electrical mains, all machine functions are
automatically cut off.
3. When the green warning light (50) turns on, the batteries
are charged.
4. Disconnect the battery charger cable (48) from the
electrical mains and place it in its housing on the machine.
5. (For WET batteries only) Close all the caps (45).
6. Close the hood (7). Now the machine is ready to be used.
NOTE
For further information about the battery charger (47)
operation, see the relevant Manual.
1464015000 - SR 1101 B
ENGLISH
17