Selecting A Base; Trouble Shooting - Topcom BUTLER 2511 DELUXE Mode D'emploi

- Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and
green LED will lit ones.
- Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover
from the headset so that the registration key hole is free also.
- Press the headset registration key. The red LED will flash rapidly.
- If after a few seconds the green LED flashes slowly, the registration is successful.
- If the red LED flashes slowly, the registration is failed. Repeat above procedure and make
sure that the base pin-code is set to '0000'!

6.5 SELECTING A BASE

The handsets can be registered up to 4 bases simultaneously.
To select a base:
1. Enter the menu by pressing
2. Select setup using the up
3. Press OK
4. Select SEL BASE using the up
5. Press OK
6. Select a base or select AUTO using the up
7. Press OK
When selecting the base, the currect selected base in indicated by a 'o' sign after the base number. If you select 'Auto'
the handset will automatically search for another base when you are out of range!

7. TROUBLE SHOOTING

Symptom
No display
No tone
The icon flashes
Base or handset do not ring
Tone is good, but there is no
communication
Not possible to transfer a call on PABX
Telephone does not react to pressing the
keys
Topcom Butler 2511 Deluxe
All manuals and user guides at all-guides.com
/OK
and down keys
and down keys
and down
Possible cause
Batteries uncharged
Handset turned OFF
Telephone cord badly connected
The line is occupied by another handset
Handset out of range
The base has no power supply
The handset is not registered on the
base
The ringing volume is zero or low
The dialling mode is wrong
The FLASH time is too short
Manipulation error
keys
Solution
Check the position of the batteries
Recharge the batteries
Turn ON the handset
Check the telephone cord connection
Wait until the other handset hangs up
Bring the handset closer to the base
Check the mains connection to the base
Register the handset on the base
Adjust the ringing volume
Adjust the dialling mode (pulse/tone)
Set the unit to Long Flash time
Remove the batteries and put them back
in place
ENGLISH
17