JVC RX-DV5SL Manuel D'instructions page 15

c Operations
Turning Off the Sounds Temporarily
From the remote control ONLY
Press MUTING to mute the sound.
"MUTING" appears on the display and the volume turns off (the
VOLUME indication goes off).
• When DVD is selected as the source with your TV turned on,
"VOLUME –" appears on the TV.
DIGITAL AUTO
L R
To restore the sound
Press MUTING again.
• Pressing VOLUME + or – on the remote control (or turn
MASTER VOLUME on the front panel) also restores the sound.
Turning Off the Power
with the Sleep Timer
From the remote control ONLY
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display.
• Each time you press the button, the shut-off time changes as
follows:
DIGITAL AUTO
L R
10
0 (off)
When the shut-off time comes
The unit is turned off automatically.
To check or change the remaining time until the shut-off time
Press SLEEP once.
The remaining time (in minutes) until the shut-off time appears.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer
Press SLEEP repeatedly until "SLEEP 0" appears on the display.
(The SLEEP indicator goes off.)
• Turning off the unit also cancels the Sleep Timer.
Note:
• If Auto Standby (see page 54) and Sleep Timer are used at a time,
one with the early shut-off time will turn off the unit.
MUTING
SPK.
SLEEP
SLEEP indicator
SPK. SLEEP
20 30 60
150 120 90
Changing the Display Brightness
From the remote control ONLY
Press DIMMER to dim the display.
• Each time you press the button, the display and
illumination lamp dim and brighten alternately.
Changing the Source Name
When you connect an CD recorder to the TAPE/CDR jacks on the
rear panel, change the source name which will be shown on the
display.
On the front panel ONLY
Ex. : When changing the source name from "TAPE" to "CDR"
1
Press TAPE/CDR (SOURCE NAME) to select as
the source.
2
Press and hold SOURCE NAME (TAPE/CDR)
until "ASSGN. CDR" appears on the display.
ANALOG
L R
ASSGN. TAPE
VOLUME
To change the source name to "TAPE"
Press and hold SOURCE NAME (TAPE/CDR) until "ASSGN.
TAPE" appears on the display in step 2 .
Note:
• Without changing the source name, you can still use the connected
components. However, there may be some inconveniences:
– The unexpected source name will appear on the display when
you press TAPE/CDR (SOURCE NAME) on the front panel.
– The CDR or TAPE button on the remote control cannot work for
selecting the source.
– You cannot use the digital input (see page 10) for the CD
recorder.
DIMMER
TAPE/CDR
SOURCE NAME
VOLUME
ASSGN. CDR
12