EN
Basic settings
Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to indicate
that the time shown is not correct.
The oven will not operate until the clock, the water
hardness parameter and the Calibration is set.
Setting the clock
To set the clock, proceed as follows:
1. Press the Clock key a few seconds. The hour
numbers will start to flash (not necessary if your
Steam oven is first plugged in or after a power
failure).
2. Press the "+" and "–" to set the correct hour
value.
Hiding/Displaying the Clock
If the clock display disturbs you, you can hide it by
pressing the Clock setting key.
Water Hardness setting
The appliance features a system that automatically
indicates when it is time to descale.
The system can be optimised for households with very
soft water (also through using a water softening
appliance) and very hard water, by changing the user
settings to the relevant range of water hardness (see
table below).
To set the water hardness parameter, proceed as
follows:
Type
Soft water
Medium water
Hard water
10
Ca + Mg
English deg.
(ppm)
[°eH]
0 to 150
0 to 11
151 to 350
12 to 25
351 to 500
26 to 35
To set the clock and the water hardness parameter
value proceed as described in the following
chapters.
3. Press again the Clock key to set the minutes.
The minute numbers will start to flash.
4. Press the "+" and "–" to set the correct minute
value.
5. To finish, press the Clock key again.
If you want to see the clock display again, press the
Clock setting key again.
1. After setting the clock the hardness number will start
to flash on the Descale display (not necessary if your
Steam oven is first plugged in or after a power
failure).
2. Press the "+" and "–" to set the correct water
hardness parameter value, according to the below
table.
3. Press the Descale key to set the parameter. The
Descale display switches off.
Water hardness
French deg.
[°dF]
0 to 15
16 to 35
36 to 50
German deg.
Display
[°dH]
0 to 8
9 to 20
21 to 28
1
2
3