Basic Settings; Initial Settings; Setting The Clock; Water Hardness Setting - Bertazzoni PROCS30X Guide De L'utilisateur

Basic settings

Initial Settings

After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock, the water
hardness parameter and the Calibration is set.

Setting the clock

Before using the oven, adjust the clock through the procedure described below but starting on Step 3.
To set the clock, proceed as follows:
1. Press the "+" key until the Clock Indicator
Light starts to flash.
2. Press the OK key.
3. Turn the "+"/ "-" Selector Knob to the left
or right to set the correct hour value.

Water Hardness setting

The system can be optimised for households with very soft water (also through using a water softening
appliance) and very hard water, by changing the user settings to the relevant range of water hardness
(see table below). To set the water hardness parameter, proceed as follows:
(The appliance features a system that automatically indicates when it is time to descale, showing the
message "".)
1. Rotate the Function Selector knob to the
position corresponding
Hardness Setting / Descaling function (not
necessary after connecting the device to the
network, or after a power failure).The water
hardness indicator light begins to flash.
to the Water
To set the clock and the water hardness
parameter value proceed as described in the
following chapters:
4. Press the OK key to validate the hour value.
The minute numbers will start to flash.
5. Turn the "+"/ "-" Selector Knob to the left
or right to set the correct minute value.
6. To finish, press the OK key again.
2. Turn the "+" / "-" Selector Knob to set the
correct water hardness parameter value,
according to the below table.
3. Press the OK key to set the parameter (or
wait until the parameter is set by time-out).
The clock is displayed.
EN
8