Safety Instructions - Bertazzoni MAST30CSEX Guide De L'utilisateur

Safety Instructions

WARNING!
Before connecting the appliance compare the
power data (voltage and frequency) indicated on
the characteristics plate with those of the power
supply in question. If these data do not match there
may be problems. In case of doubt, contact an
electrician.
WARNING!
If the electrical wire plug is removed, the appliance
must be installed and connected by a technician.
Contact a qualified electrician who knows and
respects current
manufacturer cannot be held responsible for
damage resulting from fitting or connecting errors.
WARNING!
The electrical safety of the appliance can only be
guaranteed if it is earthed. The manufacturer
cannot be held responsible for damage resulting
from the absence of or defects in the installation's
protection system (e.g. electrical shock).
WARNING!
Only use the appliance once it has been fitted into
its built-in position. Only in this manner can it be
guaranteed that users cannot access the electrical
components.
WARNING!
Never open up the appliance's frame. Possible
contacts with electrical conducting parts or changes
safety standards.
to electrical or mechanical components may
represent a danger to users' safety and prejudice
the correct working of the appliance.
WARNING!
Repairs and maintenance, especially of parts
carrying electrical current, must only be done by
technicians authorised by the manufacturer. The
manufacturer
responsibility for any damaged caused to people,
animals or property as a result of repairs and
maintenance
personnel.
The
WARNING!
Repairs undertaken during the guarantee period
must only be done by technicians authorised by the
manufacturer. If this is not the case then any
damage resulting from the repair in question is
excluded from the guarantee
WARNING!
The appliance must be disconnected from the
electrical current when installation and repair work
is being done. To disconnect the appliance from the
current, one of the following conditions must apply:
•
The switchboard fuses / circuit breakers must
be disconnected.
•
The plug should be removed from the socket.
To remove the plug from the socket do not pull
on the electric cable but rather pull out the plug
itself directly.
and retailers do
carried out by
EN
not accept
non-authorised
7