Argo X3 ECO Serie Notice D'utilisation Et D'installation page 53

Do not spill water on the remote control.
To prevent the risk of electrical shock or damage, do not attempt to
repair the air conditioner yourself. After performing the checks in
the troubleshooting section, contact an authorised service centre.
Do not obstruct the inlet or outlet. Otherwise, a fault may occur.
Contact a qualified technician if it is necessary to move the air
conditioner to another location.
Do not climb on or place heavy objects on the top panel of the
outdoor unit. Otherwise, there is a risk of damage or personal injury.
Do not put fingers or other objects in the air inlet/outlet grilles.
Otherwise, there is a risk of damage or personal injury.
The air conditioner must be properly earthed. Improper earthing
can cause electrical shock.
Always install a circuit breaker. Otherwise, a fault may occur.
The unit must be installed and serviced by a qualified technician.
Otherwise, there is a risk of damage or personal injury.
Frequency band(s) in which the radio equipment operates
2400MHz-2483.5MHz.
Maximum radio-frequency power transmitted in the frequency
band(s) in which the radio equipment operates: 20dBm.
In case of smoke or burning
smell, turn off the power supply
and contact the service center.
If the problem persists, the unit
could be damaged and cause
electrical shock or fire.
The power supply must be
equipped with a special circuit to
prevent fire.
Otherwise, it may result in fire or
electric shock.
V 01/20
WARNING
It is necessary that power supply
adopts the special circuit with
protection through an air switch
and ensure it has sufficient
capacity . The unit switches on or
off automatically according to
user needs: do not turn on or turn
off the device frequently
otherwise it could suffer harmful
effects.
Disconnect the power supply if
the air conditioner is not used for
a long time
Otherwise, the accumulation of
dust can cause overheating.
Do not cut or damage the power
cords and control cables. If the
power cable and the cable of the
control signal are damaged, they
must be replaced
professional technician.
Do not damage the power cord or
use an unauthorized cable.
Otherwise, it may
overheating or fire.
by a
cause
53