Emergency Operation; Care And Cleaning - Argo X3 ECO Serie Notice D'utilisation Et D'installation

6. How to reset the air conditioner WiFi module:
Turn off the unit with the remote control and disconnect the air conditioner power for at least 10
seconds. Reconnect the power supply. After 1 minute, press the "WiFi" and "Mode" buttons
simultaneously. If the air conditioner beeps, it means that the WiFi module has been reset
correctly.
Attention: The configuration is carried out within 2 minutes. If it does not happen within 2 minutes,
repeat the reset operation.
Analysis of common network setting errors:
If the short distance control does not work, perform the checks specified below:
• Make sure the air conditioner power is connected.
• Make sure that the air conditioner's WiFi function is normally active.
• Make sure your phone's WiFi selects the corresponding air conditioner.
• Reset with the remote control and restart the setting from step 3.
It is important to remember what is listed below.
1. The WiFi function of the air conditioner takes about 1 minute to start.
2. The air conditioner is equipped with memory function.

Emergency operation

In the event of loss or failure of the remote control, use the emergency button located under the indoor
unit's front panel to turn the air conditioner on or off.
The unit will operate in automatic mode on start-up.
MAINTENANCE

Care and cleaning

N.B.:
Disconnect the power before servicing or cleaning the unit.
Cleaning the casing of the indoor unit
Use a soft, damp cloth to clean the outer surface of the unit.
Do not use water that is too hot, solvents, petrol or other aggressive chemical compounds, talcum
powder or brushes. These may damage the colour or surface of the casing.
To remove stains, use warm water with a little neutral detergent.
Do not pour water onto the air conditioner to clean it. This may damage the internal components
or cause a short circuit.
N.B.:
Do not remove the panel when cleaning the unit.
V 01/20 76