Argo X3 ECO Serie Notice D'utilisation Et D'installation page 63

Getting to know the button combination functions
Energy saving function
In cool mode, press the TEMP and CLOCK buttons simultaneously to start or stop the energy saving
function. When you start the energy saving function, "SE" will appear on the remote control display
and the air conditioner will automatically adjust the set temperature according to the factory settings
to achieve the best energy-saving effect. Press TEMP and CLOCK again simultaneously to exit the
energy saving function.
N.B.:
• When the energy saving function is enabled, the fan will operate at the default automatic speed and
cannot be adjusted.
• When the energy saving function is enabled, the set temperature cannot be adjusted. The remote
control will not send a signal to the unit when the TURBO button is pressed.
The SLEEP and energy saving functions cannot operate simultaneously. If the energy saving
function was set in cool mode, press the SLEEP button to cancel it. If the SLEEP function was set
in cool mode, start the energy saving function to cancel it.
8°C heating function
In cool mode, press the TEMP and CLOCK buttons simultaneously to start or stop the 8°C heating
function. When this function is enabled,
air conditioner will continue to operate at 8°C. Press TEMP and CLOCK again simultaneously to exit
the 8°C heating function.
N.B.:
• When the 8°C heating function is enabled, the fan will operate at the default automatic speed and
cannot be adjusted. The remote control will not send a signal to the unit when the TURBO button is
pressed.
The SLEEP and 8°C heating functions cannot operate simultaneously. If the 8°C heating function was
set in cool mode, pressing the SLEEP button will cancel it. If the SLEEP function was set in cool
mode, starting the 8°C heating function will cancel it.
• When the temperature display is in °F, the remote control will show that the unit is operating at 46°F.
Remote control button lock function
Press " " and " " simultaneously to enable or disable the remote control button lock function.
When this function is enabled,
the remote control, the
Switching temperature display
In OFF mode, press the " " and "MODE" buttons simultaneously to switch from a temperature
display in °C to °F.
Operating guide
1. When you connect the power, press the "ON/OFF" button on the remote control to turn the air
conditioner on.
2. Press the MODE button to select the desired operating mode: AUTO, COOL, DRY, FAN or
HEAT.
3. Press " " or " " to adjust the desired temperature. (The temperature cannot be adjusted in
automatic mode.)
4. Press the "FAN" button to set the desired fan speed: automatic, low, medium or high.
5. Press the "SWING" button to adjust the fan's angle of airflow.
V 01/20
and 8°C will appear on the remote control display and the
will appear on the remote control display. If you attempt to operate
icon will flash three times and no signal will be sent to the unit.
63