I/M Readiness - Launch Creader V+ Manuel De L'utilisateur

LAUNCH
Creader V+ English User's Manual
Notes: After clearing, you should retrieve trouble codes once more or turn ignition
on and retrieve codes again. If there are still some trouble codes in the system, please
troubleshoot the code using a factory diagnosis guide, then clear the code and recheck.

4.2.3 I/M Readiness

I/M refers to Inspection and Maintenance that is legislated by the Government
EN
to meet federal clean-air standards. I/M Readiness indicates whether or not
the various emissions-related systems on the vehicle are operating properly
and are ready for Inspection and Maintenance testing.
The purpose of the I/M Readiness Monitor Status is to indicate which of the
vehicle's Monitors have run and completed their diagnosis and testing (as
described in Chapter 2.5), and which ones have not yet run and completed
testing and diagnosis of their designated sections of the vehicle's emissions
system.
The I/M Readiness Monitor Status function also can be used (after repair of
a fault has been performed) to confirm that the repair has been performed
correctly, and/or to check for Monitor Run Status.
Select [I/M Readiness] and press [ ], the screen will display the interface as
shown below:
Figure 4-10
Use [ ] / [ ] button to select and press [ ], the screen will display as below:
15