Product Information; Intended Use - EKOM ASPINA - DO M Manuel De L'utilisateur

ASPINA - DO M
Sterilizable in a steam sterilizer (autoclave) at specified temperature
Manufacturer
2.

PRODUCT INFORMATION

2.1. Intended Use

The dental aspirator ASPINA DO M is a mobile equipment extending the possibilities of procedures
provided for by a physician and ensuring the increase of ergonomy at his work. It is suitable for the
dental units not equipped with the suction equipment and a separator. It is intended for the dental
practice needs for aspiration, separation and entrapping of the waste into the built-in separation
vessel. With regard to its mobility it enables a simple transport between the workplaces and can be
used above all where the connection to a sewerage system is impossible.
The dental aspirator is designed for the operation in dry, ventilated rooms, with the ambient
temperature ranging between +5°C up to +40°C, and relative humidity not exceeding the value of
70%.

The dental aspirator may not be exposed to rain. The equipment may not be operated in the
moist or wet environs. In addition, avoid the use near gases or combustible liquids.

Other use, or the use exceeding this scope, can not be regarded as the intended use. The
maufacturer is not responsible for the resulting damages. The risk will be born exclusively by the
operator / user.
2.2. Contraindications and side-effects
There are no contraindications or side-effects known.
2.3. Product Description
(Annex No.1)
The mobile dental aspirator ASPINA DO M is built-up on a movable bogie on which is situated a box,
lined by a noise damping material. Inside the box there is situated a fan cooled suction aggregate
(9) with the electric distribution and the waste entrapping separation vessel (11). In the lower part –
under the box – there is situated a silencer with an output filter (14) and a pre-filter (15) ensuring the
air filtration from the suction aggregate. In the upper – narrowed part of the aspirator - there is
situated a holder for suction tubings (2) equipped with cannulas (1), separation automatics and
therminal box with fuses. On the lateral part there is situated a main switch (5), over which are placed
the indicators for the network (3) and for the state of filling of the separation vessel (4).
All manuals and user guides at all-guides.com
INSTALLATION – OPERATION – MAINTENANCE
- 8 - NP-DO M-37_10-2020