Lubricating The Gearbox; Cleaning The Brushcutter; Cleaning The Deflector And Cutting Attachment; Maintenance Intervals - Stihl FSA 130 Notice D'emploi

English
2
► Loosen the wing screw (1) and unscrew it until
the handlebar (2) can be rotated.
► Turn the handlebar (2) clockwise through 90°
and fold it down.
► Tighten down the wing screw (1) firmly.
► Ensure that the following conditions are met
when storing the brushcutter:
– The brushcutter is out of the reach of chil‐
dren.
– The brushcutter is clean and dry.
► If you store the brushcutter for more than 30
days: Remove the cutting attachment.
15 Cleaning
15.1

Cleaning the Brushcutter

► Switch off the brushcutter, move retaining
latch to position and pull the connecting
cable plug out of the socket.
► Clean the brushcutter with a damp cloth.
► Clean vents with a paintbrush.
15.2 Cleaning the Deflector and Cut‐
ting Attachment
► Switch off the trimmer, move retaining latch to
position and pull the connecting cable plug
out of the socket.
► Clean the deflector and cutting attachment
with a damp cloth or a soft brush.
16 Maintenance
16.1

Maintenance Intervals

The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance inter‐
vals:
After every 50 hours of operation
► Lubricate the gearbox.
Every 12 months
40
1
► Have the trimmer checked by a STIHL servic‐
ing dealer.
16.2

Lubricating the gearbox

1
► Remove screw plug (2).
► If no grease can be seen on the end of the
screw plug (2):
► Screw in the tube of STIHL gear lubri‐
cant (1).
► Squeeze 5 g of STIHL gear grease into the
gear housing.
► Unscrew the tube of STIHL gear lubri‐
cant (1).
► Refit and firmly tighten the screw plug (2) .
► Run the brushcutter for 1 minute without
load.
The STIHL gear lubricant is evenly distrib‐
uted.
16.3 Sharpening and Balancing a
Metal Cutting Attachment
Correctly sharpening and balancing metal cutting
attachments requires a lot of practice.
STIHL recommends you have metal cutting
attachments resharpened and balanced by a
STIHL servicing dealer.
► Sharpen the metal cutting attachment as
described in the instructions and on the pack‐
aging supplied with the cutting attachment you
are using.
17 Repairing
17.1 Repairing the Trimmer and
Cutting Attachment
The trimmer and cutting attachment cannot be
repaired by the user.
► If the trimmer or cutting attachment is dam‐
aged: Do not use your trimmer or cutting
attachment and contact your STIHL servicing
dealer.
15 Cleaning
2
0458-726-9621-C