Adjusting Trimmer For User; Using With Stihl Ar Battery; Using With Carrying System - Stihl FSA 130 Notice D'emploi

English
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal
cutting attachment and thrust plate.
► Remove stop pin.
7

Adjusting Trimmer for User

7.1

Using with STIHL AR Battery

7.1.1 Fitting and Adjusting the Connecting
Cable
The connecting cable can be fitted and adjusted
to suit the user's size and the application.
1
2
2
2
The connecting cable can be secured in position
by the guide (1) on the harness and the fasten‐
ers (2), or on the side of the backplate with the
fasteners (2).
3
The length of the connecting cable can be adjus‐
ted by making a loop on the backplate (3) or at
one side (4).
► Arrange the connecting cable so that it is as
short as possible without hindering your work.
7.1.2 Fitting and Adjusting the Carrying Sys‐
tem
► Put the battery on your back.
34
2
2
2
4
1
7 Adjusting Trimmer for User
► Close buckle (2) on the waist belt.
► Close buckle (1) on the chest strap.
3
► Tighten the straps until the waist belt fits
snugly on your hips and the back padding is
against your back.
► Thread the end of the waist belt through the
loop (3).
► Fit the hip pad as described in the instructions
supplied with the hip pad.
2
► Adjust the strap (1) so that the carabiner (2) is
about a hand's width below your right hip.
7.2

Using with Carrying System

7.2.1 Fitting and Adjusting the Connecting
Cable
The connecting cable can be fitted and adjusted
to suit the user's size and the application.
1
The connecting cable can be fitted through the
following openings:
– the upper left opening (1)
– the upper right opening (2)
– the lower left opening (3)
– the lower right opening (4)
1
2
3
0458-726-9621-C
4