Lubrication - Heiniger Opal Notice Originale

6.2.3 Changing the clipperhead
Fig. 22
Fig. 23
6. Fit the favoured clipperhead to the blade hinge and fold it on to the switched-
on clipper by light pressure. (fig. 17, 18, 19).
NOTE!
Only work with sharp blades, replace blunt or defective blades without teeth.
The correct resharpening of blades is only to do by special machines or by a
specialist. In that case, contact your service centre.

6.2.4 Lubrication

To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (fig. 24).
CAUTION!
Unsufficient lubrication of the clipperhead causes heating and a reduced du-
rability of clipper and blades, as well as a reduction of the battery runtime.
Therefore:
Lubricate the blades sufficiently during the clipping (at least every 15 min-
X
utes), so that they do not drain (fig. 24).
Only use the lubricants prescribed by the manufacturer.
X
NOTE!
Only use our special oil or a paraffin oil
meeting the ISO VG 15 specification.
The provided oil is non-toxic and produces no irritation on contact with the
skin or the mucous membranes. This paraffin oil degrades to some 20% after
21 days (CEL-L-33-T-82).
Translation of the original instructions / Small animal clipper
1. Move the switch to position "0" (fig.4).
2. Push the interlock clipperhead.
3. Fold the clipperhead ahead when the in-
terlock clipperhead is pressed.
4. Take off the clipperhead.
5. Clean the opened hinge by the help of
the provided brush.
15