Lubrication - Heiniger XPLORER Traduction De La Notice Originale

Fig. 13
Fig. 14
NOTE!
Only work with sharp blades, replace blunt or defective blades without teeth. The
X
correct resharpening of blades is only to do by special machines or by a specialist.
In that case, contact your service centre.
6.9

Lubrication

Fig. 15
CAUTION!
POSSIBLE DAMAGE TO THE CLIPPER!
Insufficient oiling of the clipping head will lead to warming and will shorten the life of the
clippers and its blades.
Oil the clipping blades adequately during the clipping session, at least once every
X
15 minutes, so that they do not run dry.
Only use the special oil supplied or a paraffin oil conforming to the ISO VG 15 spe-
X
cification.
Translation of the original instructions / Cattle and Horse Clipper
Place the new upper blade on the guiding tips of the
X
pivot lever.
Apply a few drops of oil on the polished surfaces of
X
the upper blade.
Install the new lower blade. Align it so that the ground
X
surface of the lower blade protrudes approx. 1.5 - 2 mm
above the point of the upper blade.
Tighten the comb plate screws.
X
To achieve a well-clipped animal and to increase the life
of the device including the clipping head, it is necessary
to apply a thin coat of oil between the upper and lower
blades. All other moving parts of the clipping head must
also be lubricated.
Apply some drops of oil on to the clipping blades and
X
into the lubrication opening.
15