Russell Hobbs 18258 Manuel page 7


Close the lid and place the kettle back on the power base. Make sure the lid is
securely closed before boiling.

Always remove the kettle from the power base before filling. Do not fill the kettle
above the MAX mark or below the MIN mark on the water gauge.
SWITCHING ON

Position the kettle on the power base.

Plug the kettle into a mains supply socket.

To start boiling the kettle, press the on/off switch down to "1" (on) position.

The power indicator light will illuminate and the kettle will start to boil.

Never open the lid during boiling.

Do not operate this kettle without the filter fitted.
Please beware of escaping steam from the lid of the kettle when in use.
USAGE STEPS

Put the power base on a flat table.

Push the button lightly to open the lid and fill in a proper amount of water. Close
the lid and put the kettle on the power base.

Connect the power cord into a suitable power outlet.

Move the switch to the "ON" position. The indicating light will go on indicating that
the heating and boiling process has begun.

Once the water has boiled, the switch will move to the "OFF" position. Disconnect
the kettle from the power supply and the indicating light will go off.

During boiling, you can move the switch to the "OFF" mark with your hand to cut
the power supply.

Pour out the water only after you have lifted the kettle from the base.

The kettle can be put on the power base but with power supply disconnected
after using.
BOIL DRY HEATING PROTECTION

If you have forgotten to add water or the water inside is below the minimum
accepted level, the metal sheet for dry heating protection of the temperature
7