Preparation For Use; Filling The Kettle - Russell Hobbs 18258 Manuel

34. Check that the lid is fully closed before switching the kettle on - otherwise it may
not switch off.
35. Check the kettle is properly located on the base before switching on.
36. Do not switch on unless the kettle contains at least 2 cups of water.
37. Do not fill past the MAX level, or it may eject boiling water.
38. Remove the kettle from its base before filling or pouring.
39. This appliance must not be operated by an external timer or remote control
system.
40. Do not put the kettle or its base on a wet place/surface or in water – do not
operate it with wet hands.
OPERATING INSTRUCTIONS

PREPARATION FOR USE

Carefully remove your kettle from the box. You may wish to retain the packaging for
further use.
BEFORE USING THE KETTLE FOR THE FIRST TIME

Before first use, fill the kettle with cold water to the MAX water level mark, bring
to boil and discard the boiling water – do this twice. This will ensure that any
residues left over from the manufacturing process are completely removed.
POSITIONING THE KETTLE

Position the power base on a dry flat surface away from any potential heat
source.

The underside of the power base is fitted with a cable storage feature. Unwind
the length of the mains cable required to reach the mains socket.

Ensure the mains cable does not hang over the work surface edge.

FILLING THE KETTLE


Remove the kettle from the power base.

Open the lid by pressing the lid release button.

Fill the kettle between the MIN and MAX markings on the water level indicator
with cold water.
6