Preparation; Bowl And Tools - Bosch MaxxiMUM MUMXX Serie Notice D'utilisation

MUMXX_en-fi.book Seite 7 Montag, 8. September 2014 3:05 15
Operation
Risk of injury!
Do not insert mains plug until all prepara-
tions for working with the appliance
are complete.
Warning!
Do not operate the appliance without
an accessory/tool in the operating position.
Do not expose appliance or accessories to
heat sources. Parts are not microwave-safe.
Before operating the appliance and

accessories for the first time, clean
thoroughly; see "Cleaning and servicing".

Preparation

Place the base unit on a smooth, clean

surface.
Prepare cable (Fig. ).

a) Appliances with cord store:
Pull out cable to the required length.
b) Appliances with automatic cord winder:
Pull out the cord in one go to the required
length (max. 100 cm) and slowly release;
the cord is locked.
Reducing the cord length:
Pull gently on the cord and allow
it to roll up to the required length.
Then gently pull the cord again and
slowly release; the cable is locked.
Warning!
Do not twist the cord when inserting it.
If the appliance features an automatic
cord winder, do not insert the cord manually.
If the cord jams, pull out the cord all the way
and then allow it to wind up.

Bowl and tools

Risk of injury from rotating tools
While the appliance is operating, never
place fingers in the mixing bowl.
Attach the cover (12) before operating
the appliance!
Keep hands clear of rotating parts.
Do not change tools until the drive has
come to a standstill – when the appliance
is switched off, the drive continues running
briefly and stops in the tool change
position.
Robert Bosch Hausgeräte GmbH
All manuals and user guides at all-guides.com
Do not move multi-function arm until
the tool is at a standstill.
Do not move multi-function arm until
the tool is at a standstill.
For safety reasons the appliance cannot
be operated in Pos. 2–4 until the bowl has
been inserted and turned all the way or the
tool drive cover (8) has been attached.
Warning!
Use bowl with this appliance only.
Insert tools firmly into the drive until they lock
into position.
"Absolute" stirrer (15)
for stirring dough, e.g. sponge mixture
or mousse, and for folding in beaten
egg whites or cream.
Solid metal whisk (16)
for whisking egg whites, cream and
light dough, e.g. sponge mixture
Kneading hook "High performance"
with dough deflector (17)
for kneading heavy dough and mixing-
in ingredients that ought not be cut
(e.g. raisins and chocolate chips).
Important information
concerning the use
of the whisk
The whisk should just touch the bottom of the
bowl in order to mix the ingredients thoroughly.
This is also important to ensure that the
automatic SensorControl functions. The whisk
can be positioned higher for large quantities.
Adjust the height of the whisk as follows:






Remove mains plug.
Press release button and move multi-
function arm to position 1.
Insert the whisk into the drive until
the whisk locks into position.
Hold whisk in place and loosen
nut clockwise using enclosed key
(on the base of the appliance).
Set the whisk to the optimum height
by rotating the whisk:
– Turn clockwise: Raise
– Turn anti-clockwise: Lower
Press release button and move
multi-function arm to position 2.
Check the height of the whisk and,
if required, correct.
en
Fig. 
7