Operation; Preparation - Bosch MUM5 Serie Notice D'utilisation

MUM5xxx_de-ar.book Seite 20 Donnerstag, 25. September 2014 9:59 09
en

Operation

Risk of injury!
Do not insert mains plug until all
preparations for working with the
appliance are complete.
Attention!
Do not operate the appliance without an
accessory/tool in the operating position.
Do not operate the appliance empty.
Do not expose appliance or accessories to
heat sources. Parts are not microwave-safe.
Before operating the appliance and

accessories for the first time, clean
thoroughly; see "Cleaning and servicing".
Important information
In these instructions for use the recom-
mended reference values for the opera-
ting speed refer to appliances with a 7-
setting rotary switch. For appliances with
a 4-setting rotary switch you can find the
values in brackets after the values for a 7-
setting rotary switch.
These operating instructions contain
a sticker with reference values for the
operating speed of the appliance when
using the tools or accessories.
We recommend attaching this sticker
to the appliance (Fig. ).

Preparation

Place the base unit on a smooth,

clean surface.
Pull out the power cord (Fig. ).

MUM52../MUM54..
Cord store:
Pull out cable to the required
length.
MUM55../MUM56..
Automatic cord winder:
Pull out the cord in one go
to the required length (max.
100 cm) and slowly release;
the cord is locked.
Reducing the cord length:
Pull gently on the cord and allow it to roll
up to the required length. Then gently pull
the cord again and slowly release; the
cable is locked.
20
Warning!
Do not twist the cord when inserting it.
If the appliance features an automatic cord
winder, do not insert the cord manually. If the
cord jams, pull out the cord all the way and
then allow it to wind up.
Insert the mains plug.

Bowl and tools
Risk of injury from rotating tools
While the appliance is operating, never
place fingers in the mixing bowl. Attach the
cover (12) before operating the appliance!
Do not change tools until the drive has
come to a standstill – when the appliance
is switched off, the drive continues running
briefly and stops in the tool change
position. Do not move the swivel arm until
the tool has come to a standstill.
For reasons of safety the appliance may
only be operated when unused drives have
been covered with drive guards (5, 8).
Attention!
Use bowl with this appliance only.
Stirrer (13)
for stirring dough, e.g. cake mixture
Whisk (14)
for whisking egg whites, cream and
light dough, e.g. sponge mixture
Kneading hook (15)
for kneading heavy dough and mixing-
in ingredients that ought not be cut
(e.g. raisins and chocolate chips)
Working with the bowl and the tools Fig. 
Press the Release button and move

the swivel arm to position 2.
Insert the bowl:

– Tilt the bowl forwards and then set it
down.
– Turn anti-clockwise until it locks into
place.
Depending on the processing task, insert

the stirrer, whisk or kneading hook until it
locks into position.
Note:
If using the kneading hook, rotate the
dough deflector until the kneading hook
can lock into position (Fig. –4b).
Robert Bosch Hausgeräte GmbH