Using The Blow Gun; Maintenance And Cleaning; Service - Parkside PDSS B2 Instructions D'utilisation Et Consignes De Sécurité

Bringing into use / Maintenance and cleaning / Service
5. Press the lever of the valve connector
wards and pull the valve connector
valve.
6. After you finish work, disconnect the device from
the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.
Using accessories:
P ress the lever of the valve connector
insert the desired accessory
into the valve connector
9
(see Fig. F), e.g. cycle tyre valve; (Dunlop
valve (see Fig. G), traditional cycle tyre valve).
TIP: Use the valve adapter
valves shown.

Using the blow gun

Q
1. Screw an extension nozzle
gun .
7
2. Press the trigger
6
3. Release the trigger
4. After you finish work, disconnect the device
from the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.

Maintenance and cleaning

Q
Always disconnect the device from the compressed
air source before you clean or maintain it.
The device requires no maintenance.
D o not use sharp objects for cleaning the device.
Do not allow any liquids to enter the device.
Otherwise the device could be damaged.
20 GB
down-
5
off the
5
and
5
to or the cap
10 13
(Presta valve
5
for the cycle tyre
13
7
on to the blow
8
to start the delivery of air.
to stop the delivery of air.
6
DANGER OF INJURY!
C lean the device frequently; for best results, do
this immediately after you have finished using it.
C lean the housing with a dry cloth.

Service

Should problems arise whilst operating your ROWI
Electronics product, please proceed as follows:
1. contact us
You may contact the ROWI Electronics Service
Team at:
ROWI Electronics GmbH
Augartenstr. 3
76698 Ubstadt-Weiher, Germany
Id-services@rowi-electronics.com
Service hotline: +49 (0) 7253 9460-40
Most problems can be resolved with the skilled
technical support of our Service Team.
2. Should an inspection or repair by the
ROWI Electronics Service center be
required, please proceed as follows:
– Pack product
Pack the product in the original packaging.
Ensure it is adequately padded and protected
from impact. Transport damage is not covered
by the warranty.
– Include receipt
The sales receipt must be included. Repairs
under warranty can only be processed with
the sales receipt.
– Send product
Only send the product to the above address
after contacting the ROWI Electronics Service
Center.