Attaching/Disconnecting The Battery Pack To/From The Appliance; Operating The Cordless Air Pump Palp 20-Li A1; Inflation; Deflation - Parkside PALP 20-Li A1 Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
Allow the battery pack
handle.
Removing the battery pack:
Press the release button
battery pack
Checking the battery charge level:
Press the battery charge level button
check the battery charge level.
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Operating the cordless air
pump PALP 20-Li A1
This appliance is not designed for continuous
operation. The appliance may be used for a maxi-
mum of 20 minutes of continuous operation. If the
appliance overheats, remove the battery pack
Allow the appliance to cool down completely and
then try using it again.
Inflation
Remove the valve cap of the item you want to
inflate.
Fit the appropriate adapter
the pump air outlet
Push the adapter
the item to be inflated.
Turn on the device by pressing the ON / OFF
switch
.
When the desired fill volume has been reached,
switch off the device by pressing the ON / OFF
switch
again.
Now remove the adapter
Replace the valve cap on the item that you have
inflated.
GB │ IE
22 
to click into the
and remove the
.
as follows:
,
or
onto
.
,
or
into the valve of
,
or
.
Deflation
Fit the appropriate adapter
the pump air inlet
Remove the valve cap of the item you want to
deflate and push the adapter
the valve of the item to be deflated.
Switch the appliance on by pressing the
ON/OFF switch
Once the item is fully deflated, switch off the
appliance by pressing the ON/OFF switch
again.
to
Now remove the adapter

Adapters

Adapter
:
For standard valves with an internal diameter of
8 mm.
Adapter
:
For inflatable items with a screw valve. Deflation
is only possible with an unscrewed valve and with
this adapter.
Adapter
:
.
For inflatable items with a deflation valve.
NOTE
The LED work lamp
as you press the ON / OFF switch
allows illumination of the working area while
inflating in low light conditions.
PAK 20-Li A1 / PALP 20-Li A1
,
or
onto
.
,
or
.
,
or
.
lights up as soon
. This
into

Publicité

Table des Matières
loading

Table des Matières