Attaching/Disconnecting The Battery Pack To/From The Appliance; Operating The Cordless Air Pump Palp 16 A1; Inflation; Deflation - Parkside PAK 16 A1 Traduction Des Instructions D'origine

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Allow the battery pack
handle.
Removing the battery pack:
♦ Press the release button
battery pack
Checking the battery charge level:
♦ Press the battery charge level button
check the battery charge level.
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Operating the cordless air
pump PALP 16 A1
This appliance is not designed for continuous
operation. The appliance may be used for a maxi-
mum of 20 minutes of continuous operation. If the
appliance overheats, remove the battery pack
Allow the appliance to cool down completely and
then try using it again.
Inflation
♦ Remove the valve cap of the item you want to
inflate.
♦ Fit the appropriate adapter
the pump air outlet
♦ Push the adapter
the item to be inflated.
♦ Switch the appliance on by pressing the ON/
OFF switch .
♦ Once the desired level of inflation has been
reached, switch off the appliance by releasing
the ON/OFF switch
♦ Now remove the adapter
♦ Replace the valve cap on the item that you have
inflated.
│ GB │ IE │ NI
■ 8
to click into the
and remove the
.
as follows:
, or onto
.
, or into the valve of
.
, or .
Deflation
♦ Fit the appropriate adapter
the pump air inlet
♦ Remove the valve cap of the item you want to
deflate and push the adapter
the valve of the item to be deflated.
♦ Switch the appliance on by pressing and holding
the ON/OFF switch
♦ Once the item is fully deflated, switch off the ap-
pliance by releasing the ON/OFF switch
to
♦ Now remove the adapter

Adapters

Adapter :
For standard valves with an internal diameter of
8 mm.
Adapter :
For inflatable items with a screw valve. Deflation
is only possible with an unscrewed valve and with
this adapter.
Adapter :
For inflatable items with a deflation valve.
.
NOTE
► The LED working light
OFF switch
This allows illumination of the working area
while inflating in low light conditions.
, or
.
, or
.
, or
is lit when the ON/
is lightly or fully depressed.
PAK 16 A1 / PALP 16 A1
onto
into
.
.