Bronpi SYDNEY Manuel D'utilisation page 13

Table des Matières

Publicité

2.4 VENTILATION CONNECTION – ELECTRICAL SYSTEM (only sydney-T
model)
ENG The Sydney-T model has a fan of 270 m
distribution through the environment ventilation.
The ignition and ventilation control is performed by the regulator knob
located on the right rear part. This regulator has the following functions:
Position OFF: the fan will remain switched off as long as there is no
-
combustion inside the firebox as the stove has a thermostat that
controls fan operation depending on the temperature of the stove.
-
Position ON: the fan will remain switched on although there is no
combustion inside the firebox.
In all cases, you will be able to choose the operating speed of the fan
through the regulator.
CONNECTION:
The conductor connected to network is located on the right rear part of the
stove. It is advisable not to cut it completely because it is useful when
replacing electrical components inside.
It is essential the proper connection to the grounding system.
The installation of the appliance must be carried out by qualified and
authorized personnel in accordance with current regulations.
SUBSTITUTION:
In case of replacement of one of the electrical components, the replacement
operation can be performed through the frontal part of the stove, without
necessity of uninstalling it, as follows:
-
First, unscrew the fan protection, loosening the screw on each side.
-
Once the protection has been removed, you will have direct access
to the thermostat as well as to the connections card, leaving the fan
completely visible.
-
In order to remove the fan, just raise it and release it from its
attachment to the stove.
-
Disconnect and replace damaged items and reassemble everything
as it was.
2.4 LIGAÇÃO DA VENTILAÇÃO – SISTEMA ELÉCTRICO (SÓ MODELO Sydney-
T)
POR
O modelo Sydney-T possui um ventilador de 270m3/h, servindo para
melhorar a distribuição do calor pelo ambiente mediante a ventilação.
O acendimento e a regulação da ventilação são feitos através do botão de
regulação situado na parte traseira direita. Este regulador tem as seguintes
funções:
All manuals and user guides at all-guides.com
3
/h in order to improve heat

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sydney-t

Table des Matières