Custom Settings - Stealth Cam STC-DS4KMAX Mode D'emploi

CUSTOM – This is the fifth setting and is defined by the user. When the camera is changed to this
mode, the display screen will reflect the last program setting: Number of images on the memory
card, Countdown timer and Battery percentage.
The Day default programming is set to 8.0MP, 5-second timeout delay and 1 Photo Burst; the Night
default programming is set to 6.0 MP, 5-second delay and 1 Photo Burst. The 30-second timer on
the lower left of the display will count down towards 0 showing how much time is left to enter
the Custom configuration mode. Should no change be made, the system will give an additional 30
seconds for the operator to move out of the coverage area before the camera becomes
active.
To make changes to the programming, press the MENU button to enter the configuration menu
before the countdown reaches zero. When in the MENU configuration, pressing the DOWN
arrow button will move the configuration to the next setting option. Pressing the ENTER button
on the listed configuration option will cause the option to blink and allow it to be changed.
Pressing ENTER again once an option has been changed will set the new configuration, save it to
the camera's memory, and return to selection section of the MENU configuration. Once all the
settings have been changed to the operator's desired settings pressing the MENU button will
return to the initial display and the 30-second timer will start the countdown again.
The following are the options and descriptions of how to change the configuration:
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING – CUSTOM (CONT)
PHOTO
00:30
00000
100%
8
Page