Battery Removal & Installation - Stealth Cam STC-DS4KMAX Mode D'emploi

To remove the batteries from the unit; open the case and
press the EJECT button on the lower right hand corner.
This will cause the battery tray to be released and slide
downwards.
To reinsert the battery tray; position the tray so the base of the tray matches with the opening at
the bottom of the camera. The tray is notched so that incorrect insertion of the battery tray is not
possible. With the orientation correct simply slide the battery tray into its final locked position.
Should the battery tray not willingly slide into it destination, remove the tray and examine the
area of possible debris that may be causing the issue.
NOTE: Replacing the batteries will not reset the cameras current configurations.
Remove batteries from the tray if the unit will not be in use for extended period of time.
www.stealthcam.com
877-­‐269-­‐8490
BATTERY REMOVAL & INSTALLATION
New, Alkaline or Lithium, 'AA' batteries must be inserted
with the orientation as shown on the tray. As with most
electronic devices the negative ( -­‐ ) orientation of the
batteries should be against the springs. Failure to insert
the batteries properly will cause damage to the unit.
**WARNING**
Do not mix new and old batteries.
23
Page