Stealth Cam STC-DS4KMAX Mode D'emploi page 14

PIR COMBO: In this mode the camera will take a video and photos simultaneously. The video clip is at a
o
designated resolution for the designated length with a designated time out when the camera senses activity
in front of the unit. While taking a the video the camera will begin saving frames as images with the same
resolution as the video starting with the first frame and an additional frame every 5 seconds of video record.
This mode is available for both day and night activities.
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the
"
camera will wait before it reinitializes its PIR sensor for the next activation. With the TL mode this
setting is only active if TL Delay is set to 1 min or greater. This setting can be changed between the
numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the UP and DOWN
arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is on the
appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to
59 if minutes = 00).
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR
"
will be activated. These distances can vary depending on environmental conditions. This setting will
change between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the
STANDARD setting, or NEAR FIELD that will only trigger on movement closest to the camera.
VIDEO RES – 1920 x 1080 (default): This setting is used to determine the resolution of each video
"
taken by the camera. With this option blinking, use the UP or DOWN arrow key to move between
the options of: 1920 x 1080 or 1280 x 720. The higher the resolution of a video the more space the file
will take on the SD memory card.
VIDEO LENGTH – 010 S (default): This setting is used to determine the length of time, in seconds, of
"
the video recording. This setting can be changed between the numbers of 5 to 180. With this
option blinking, use the UP or DOWN arrow key to move between the value range in increments of
5.
VIDEO AUDIO – ON (default): This setting is used to determine if the camera should record audio
"
(sound) with its video recording. With this option blinking, pressing the UP or DOWN arrow buttons
will cause the camera to cycle between the two options of ON or OFF.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
The maximum night video is 30 seconds to conserve the batteries.
14
Page