EUROM GOLDEN 2000 AMBER SMART Rotary Mode D'emploi page 20

 Remove the batteries out of the season, that will extend the life of the remote
control.
 When you use the appliance for the first time (or after a long time again), observe it
during the first 10 till 15 minutes to be sure that is works trouble-free.
The reset button
You can use the reset button in three situations (see below):
- To operate the device without the remote control. Every time that you press the reset
button (briefly), the output changes from: > 2000 W > 1320 W > 660 W > off.
- To switch the device back on without the remote control, after the shock safeguard
has turned it off (see: Shock safeguard).
- To set or change the password for the app control.
App control
The EUROM GOLDEN 2000 AMBER SMART ROTARY can also be controlled by an app that
has been downloaded to a tablet or smart-phone (via a blue tooth connection). This app
is available in the app store for Apple devices and can be found under EUROM heating. It
is available for Android in the Google Play Store.
If you have switched the device on with the
app and then continue to control it with the
remote control or manual controls, the
bluetooth connection will be broken. If you
then wish to reuse the app controls, you must
first restore the blue tooth connection.
With the app, you can:
- Remotely switch the device on and off
- Gradually adjust the heat from 0 to 100%
- Set a timer that automatically switches the
device off
- Set the sensitivity of the shock safeguard
- Set multiple heaters individually
The app controls are secured with a password.
Shock safeguard
The EUROM GOLDEN 2000 AMBER SMART ROTARY has the option of a shock safeguard
that switches the device off if it is shocked in any way. The shock safeguard can be
activated with the app and the sensitivity can then be set on a sliding scale. When the
device is supplied from the factory, the shock safeguard is off. Once the shock safeguard
has been activated, it can be operated via the remote control or manually. If the shock
safeguard has switched the device off, the red light at the reception point will blink.
Check to ensure that the device has not been damaged. If everything is ok, you can
restart the device by:
- Using the remote control to switch the device off and then on again
- Switching it off and on again using the switch, and then selecting the desired output
using the reset button (remote control)
- Switching the device off and on again with the app
All manuals and user guides at all-guides.com
20