EUROM GOLDEN 2000 AMBER SMART Mode D'emploi page 20

supplied).
 Hook one end of the chains onto suspension points of the heater by means of the
karabiner hook. You hook the karabiner hooks at the other end of the chain through
the suspension eyes in the ceiling. Pulling the chain through the suspension eye and
fastening the second karabiner hook to the chain allows you to raise the suspension
height of the heater. You can also wrap the chain around a horizontal beam or rod (see
picture).
Please always take account of the minimum distances to the ceiling, floor, walls and
objects and make sure the heater is horizontal!
The following applies for all options:
 However you install the GOLDEN AMBER SMART, always lead the electrical cable
directly away from the heater. It may not become hot!
 Adjust the desire radiation angle of the device. Do this by undoing both Allen screws
slightly using the Allen key. Make sure you secure them again once you have made the
adjustments! The heater can rotate through approximately 90° - with wall fastening
from 30° upwards to approximately 60° downwards. When adjusting the angle ensure
that the radiator does not radiate heat onto flammable materials from a short
distance!
 Fasten all screws another time firmly and scheck or the heater is firmly mounted. Now
your infra red heater is ready for use.
 For personal protection the installation, to which the EUROM GOLDEN 2000 AMBER
SMART is connected, has to be equipped with an earth fall device (max. 30 mAmp).
Under some circumstances it may be attractive to make a fast connection between the
heater and the main supply, and to operate the heater with a switch. Because the
EUROM GOLDEN 2000 AMBER SMART has a high water tightness (IP65) and for safety
reasons, such a connection has to be made by a qualified electrician.
WORKING
Check for every use:
- o the applia e does t sho sig s of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o
wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
The Golden 2000 Amber Smart has a remote control that works with two batteries: AAA,
1.5V.
While using, point the remote control to the receiving point of the heater. If there are
obstacles between remote control and the heater, it will not work!
All manuals and user guides at all-guides.com
20