Assembly
1. Insert valve seat (7) with the ball seat surface facing up
into the housing (8).
2. Insert O-ring (6) into the housing (8).
3. Insert filter cartridge (3).
4. Place thin seal (5) on threaded section of housing (8).
5. Place thick seal (4) on top of thin seal (5).
6. Slide pressure spring (2) onto housing cover pin (2).
7. Screw on housing cover (1) and tighten by hand.
8
HC 920 • HC 940 • HC 960
All manuals and user guides at all-guides.com
GB
8.4
Intake filter in Airless spray gun
Dismounting (fig. 17)
3. Intake filter congested or defective – replace.
1
Mounting
1. Place intake filter (3) with the long cone into the gun
2
3
4
5
6
7
45
Cleaning Airless spray gun
– Rinse Airless spray gun with an appropriate cleaning
agent.
– Clean tip thoroughly with appropriate cleaning agent so
that no coating material residue remains.
– Thoroughly clean the outside of the Airless spray gun.
1. Pull protective guard (1) forward vigorously.
2. Screw handle (2) out of the gun housing. Remove intake
filter (3).
housing.
2. Screw handle (2) into the gun housing and tight en.
3. Snap in protective guard (1).
1
Cleaning the unit (shutting down)
3
2