Battery Charging; Getting Started - XciteRC Flybar 190E Single Blade Mode D'emploi

Battery charging · Getting started
5. Throttle position
6. Forward lever level
7. Direction lever right
8. Backward lever level
9. Direction lever left
10. Yaw right
11. Yaw left
12. High-Speed mode on „H"
13. High-Speed mode off „L"
14. Tranmitter power level
15. MODE 1 activated
16. MODE 2 activated
17. Signal strength

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fi reproof surface and under constant adult supervision -
fi re or explosion hazard!
• Insert the plug of the USB cable into the socket of the char-
ger.
• Connect the helicopter battery with the charger.
• WARNING: The helicopter battery is polarized. Check
the side channels. Do not use force - fi re or explosion ha-
zard!
• The red LED lights to indicate charging. Charging time is
about 50-60 minutes. If the battery is fully charged, the red
LED goes out.
• Unplug the battery and the USB cable.
The fl ight time of the helicopter is about 6-8 minutes.

Getting started

Before you begin please check:
• WARNING: Only start with a suffi ciently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the fl ying qualities.
• Insert the battery in the battery holder on the landing gear.
• WARNING: The helicopter battery is polarized.
Check the side channels. Do not use force - fi re or ex-
plosion hazard!
• The red LED on the receiver board starts to fl ash.
• Then switch on the transmitter. The POWER LED fl ashes.
• Place the helicopter in the start position and move the left
throttle lever all the way up and then back in the lowest
position. This safety circuit prevents the rotor may start
after turning ON the helicopter
• The transmitter LED and the red helicopter LED will now
light.
• Check the motor and servo functions.
XciteRC Flybar 190E Easy
9
Red LED off Red LED on
Charging completed Charge
EN
19