Battery Charging; Getting Started; Rc Functions - XciteRC Flybar 290E Easy Mode D'emploi

Battery charging · Getting started · RC functions

Battery charging

WARNING: Be sure to read all safety instructions regarding
the use of rechargeable batteries. Charging may take place only with
the supplied charger on a fireproof surface and under constant adult
supervision - fire or explosion hazard!
• Connect the USB cable with a PC or USB mains adapter. The
red LED lits.
• WARNING: To charge the LiPo flight battery, do not use
USB power adapters or quick-charging devices with more than
1 A output current, otherwise the battery may blow up and gets
defective - fire or explosion hazard!
• Connect the charging wire with the helicopters charging socket.
• The red LED goes out to indicate charging. Charging time is about 90 minutes. If the battery is fully char-
ged, the red LED goes on again.
• Unplug the battery and the USB cable.
The flight time of the helicopter is about 6-8 minutes.

Getting started

Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
• Switch on the helicopter with the switch at the bottom - switch in the ON position. The red LED on the
receiver board starts flashing. Place the helicopter on a flat surface in the starting position.
• Then switch on the transmitter. The POWER LED flashes.
• After a few seconds, the POWER LED of the transmitter and the red LED of the helicopter are permanently
red - the helicopter is now ready for flight.
• Check the motor and servo functions.
• If the flight battery runs low, the motor speed is reduced and the helicopter sinks automatically. Find a
suitable place to land safely. Charge the flight battery again.

RC functions

Up - down
Move the throttle lever forward, the motor revs
up and the helicopter rises. Move the throttle
lever backwards to sink again.
XciteRC Flybar 290E Easy
Trim up - down
If the rotor turns, even when the throttle lever
is fully down, keep pressing the trim button
down until it stops. If it will not turn, even when
you give gas, trim upwards.
Mains adapter
(not included)
USB charging wire
EN
17