The Remote Control System; Transmitter; Battery Charging - XciteRC Flybar 180C Coax Cam Mode D'emploi

The remote control system

Here you get an overview of the remote control system of your XciteRC Flybar 180SC and its various features
and settings. Before the first flight, you should absolutely have read and understood all these functions and
EN
settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the back side of the transmitter. Remove the screw and
open the cover (1). Insert six AA batteries into the battery compartment of the transmitter (2). Pay attention
to the correct polarity!
• Close the battery compartment cover, then turn on transmitter – push ON / OFF switch.
• When the POWER LED is flashing, move the left throttle lever to the top position, then back to the bottom.
The POWER LED will light constantly. This safety circuit prevents the rotor may start after turning on the
helicopter.
• The POWER LED must lit. Attention: if the POWER LED flashes or does not light at all, the model may
not started – crash hazard! Change transmitter batteries immediately.
• WARNING: check the POWER LED also during operation. If the POWER LED starts to blink, stop
operation, switch the model off and replace the transmitter batteries – crash hazard!
• ATTENTION: The maximum range of the remote control system is about 10 meters, do not fly
farther away under any circumstances! If the XciteRC Flybar 180SC gets out of range, the fail-safe func-
tion is activated and turns off the motor.

Transmitter

Channel select
Throttle lever
Charging
connector

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
16
ON/OFF Switch
IR-Transmitter
Picture Video
The remote control system
Trim wheel
Direction
lever
POWER-LED
Battery Cover
6x 1.5 V AA
Batterien
ATTENTION:
IR-Transmitter must always
point toward the helicopter -
crash hazard!
The helicopter can be ope-
rated with two different
channels (A-B) - important
when two pilots wants to fly
together. Select the channel
on the transmitter, switch on
the heli, when the LED on
the helicopters PCB start to
lit you can start.
XciteRC Flybar 180SC Coax
The