Transmitter; Binding; Charging The Battery - XciteRC one16 Série Mode D'emploi

Transmitter

EN
A: Steering wheel: direction right or left
B: Throttle trigger: controls the speed and direction of the model
C: Battery compartment
1. Control trim: adjusts the straight ahead driving
2. Servoreverse steering
3. POWER LED: indicates the battery voltage
4. On / Off Switch: Turns the power of the transmitter ON / OFF
5. Steering Dual Rate: sets the maximum curve radius
6. Throttle trim: adjust the neutral position of the controller (always in the middle position!)
7. Servoreverse throttle
8. BIND-LED: indicates a "bound" receiver
9. BIND (pair)-button
NOTE: the adjuster for the throttle trim TH.TRIM and the servo reverse switches for steering ST.REV
and throttle TH.REV must not be adjusted. So check the correct position before every ride: throttle trim to the
center position (mark on the adjuster points up), steering reverse: switch in position N, servo reverse throttle:
switch also in position N.

BINDING:

The 2.4 GHz receiver of One16 must be once „connected" with a suitable transmitter, the so-called „binding"
procedure. This ensures that the receiver establishes a connection only with this transmitter and the model
can be operated without interference. This process can be repeated any time.
The transmitter and receiver of the One16 are already bound so that you can start flying immediately. Should
a rebind gets necessary (eg. after a transmitter change), proceed as follows:
• Make sure that no other 2.4 GHz network (eg. WLAN or other transmitter) sends nearby.
• The distance between transmitter - One16 should be maximum one meter.
• Switch the vehicle ON. Within 5 seconds press and hold the PAIR button on the transmitter and turn it on.
The green LED starts flashing to indicate the binding process. After about 5 seconds, both LEDs light up
continuously, the transmitter is now bound to the One16.
• If the model cannot be controlled, repeat the process.

Charging the Battery:

Before the first use of your new model the drive battery needs to be charged with the included charger.
WARNING: Charge may occur only with the supplied charger on a fireproof surface and under cons-
tant adult supervision - fire or explosion hazard!
18
A
B
1
2
3
4
C
Transmitter · Binding
5
6
7
8
One16 series
9