Assembly; Charging The Battery; Insert The Battery; Getting Started - XciteRC one10MT Mode D'emploi

Assembly · Charging · Insert the battery · Getting started

Assembly:

Before the first ride you should mount the wheeliebar with the enclosed screws.

Charging the Battery:

• Connect the charger to a suitable mains socket (100 - 240 V AC 50/60 Hz).
• Now plug the drive battery into the charger and the charging process starts.
• WARNING: The battery plug is protected against polarity reversal. It must snap in easily, not use
force - fire hazard!
• The charging time is approx. 4 hours. Disconnect the battery from the charger and after the charger from
the mains socket.

Insert the battery

WARNING: The battery plug is protected against polarity reversal. It must snap in easily, not use force
- fire hazard!

Getting started

Insert the battery into the vehicle and connect the plug to the ESC. Before you start, check all functions of
the remote control. Does the vehicle follow exactly and directly your commands? Or does it react delayed
or choppy? If yes, do not start anyway, but check transmitter and drive batteries and recharge or replace if
necessary.
One10 MT
Before the first use of your new model the drive battery needs to be
charged.
ATTENTION: Make sure to read all safety instructions regarding
the use of rechargeable batteries. Also, if necessary, further safety
instructions in the manual for your used charger.
WARNING: Charge may occur only with the supplied charger
on a fireproof surface and under constant adult supervision - fire or
explosion hazard! For charging remove the battery from the vehicle.
1 2 3
EN
4
19