Landing; Maintenance - XciteRC Flybar 190E Single Blade Mode D'emploi

Left - Right
Move the direction lever to the left, the helicop-
ter turns to the left. Move it to the right to turn
EN
the helicopter to the right.
Left - Right
Move the direction lever to the left, the helicop-
ter turns to the left. Move it to the right to turn
the helicopter to the right.
Speed: press the button during the fl ight and the helicopter becomes faster (display H). Press again to return
to slower speed (display L).

Landing:

• Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the helicopter.
• NOTE: if the fl ight battery runs empty, the helicopter does not respond accurately to your com-
mands, the fl ight is unstable. In this case land immediately.
• Switch of the helicopter and then the transmitter.
WARNING: the motor of the XciteRC FLYBAR 190E may get very hot during operation. Allow to cool
down minimum 20 minutes before the next start to avoid damage. Fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fi re hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fi re hazard!
22
Speed · Landing · Maintenance
Trim left - right
When hoovering, the helicopter must stand in
place. If it moves to the right, move the trim but-
ton to the left until it stops, or vice versa.
Trim left - right
When hoovering, the helicopter must stand in
place. If it moves to the right, move the trim but-
ton to the left until it stops, or vice versa.
XciteRC Flybar 190E Easy