Charging The Battery; Insert The Batteries - XciteRC twenty4 Série Mode D'emploi

Charging and inserting the batteries

Charging the Battery:

Before the first use of your new model the drive battery needs to be charged.
ATTENTION: Make sure to read all safety instructions regarding the use of rechargeable batteries.
Also, if necessary, further safety instructions in the manual for your used charger.
WARNING: Charge may occur only with the supplied charger on a fireproof surface and under cons-
tant adult supervision - fire or explosion hazard!
• Connect the plug of the power supply with the charger (2).
• Connect the power supply with a suitable power outlet 110-240 V AC - 50/60 Hz. Both charge indicator
lights flash alternately red and green.
• Insert the batteries in the charger (3).
polarity - risk of fire or explosion!
• The LEDs now light up red, the batteries gets charged.
• When the batteries are fully charged, the LEDs change to green. Remove the batteries and disconnect
the power supply from the power outlet. The charging time is approx. 90 minutes.
1

Insert the batteries:

NOTE: use only the included Li-Ion batteries for the vehicle!
WARNING: Make sure to read all safety instructions regarding the use of rechargeable batteries. Also,
if necessary, further safety instructions in the manual for your used charger.
WARNING: insert the rechargeable batteries with the correct polarity - fire or explosion hazard!
The contacts of the battery holder in the vehicle can fail by frequently changing the batteries. You recognize
that in short breaks while driving. Slightly turn them into contact with a screwdriver so that they fit correctly
to the battery cells!
twenty4 series
WARNING: Insert the rechargeable batteries with the correct
2 3
EN
19