ATIKA MHB 40 Notice Originale page 21

UPPER MARK
LOWER MARK
2. Insert the dipstick without tightening the oil filler plug. Check
the oil level on the dipstick.
3. If the oil level is too low: Fill with the recommended oil to the
rim of the filler neck.
4. Screw the oil filler plug with the dipstick tight.
Operating the engine with the oil level too low may damage it.
ENGINE OIL CHANGE
Drain the used oil as long as the engine is still warm. Warm oil
drains quickly and completely.
1. Place a suitable vessel under the engine to collect the used
oil. Unscrew the oil filler plug and the oil drain plug.
OIL FILLER PLUG / OIL DIPSTICK
OIL DRAIN PLUG
2. Drain the oil completely. Now install the oil drain plug again
(tighten).
Dispose of the used oil in an environmentally compatible
manner. We recommend bringing the used oil in a tightly
closed container to your local service station or petrol
station. Do not discard used oil with the domestic waste; do
not dispose of into the soil or pour it into the sewer drain.
All manuals and user guides at all-guides.com
MAX
MIN
SEAL RING
MAINTENANCE
3. Place the engine on a level surface and fill it to the rim of the
filler neck with the recommended oil.
Engine oil amount: 0.6 l
Operating the engine with the oil level too low may damage
it.
4. Screw the oil filler plug with the dipstick tight.
ENGINE MAINTENANCE
AIR FILTER INSPECTION
Remove the air filter cover and inspect the filter. Clean or replace
the soiled filter elements. Make sure to replace damaged filter
elements.
FOAM FILTER ELEMENT
AIR FILTER MAINTENANCE
A soiled air filter reduces the air supply to the carburettor and
thus the engine power.
When operating the engine in dusty environments the air filter
must be cleaned more often than specified in the
MAINTENANCE PLAN.
1. Remove the air filter cover and the air filter.
Foam air filter element: Clean in warm soap water, rinse
thoroughly and dry well. Submerge the filter element in
clean engine oil and squeeze out the excess oil. The engine
smokes
if the foam contains too much excess oil.
2. Wipe off the dirt from the inside of the air filter bracket using
a wet rag. Make sure that no dirt enters the air line to the
carburettor.
3. Install the air filter cover.
Operating the engine without air filter or with damaged air
filter allows dirt to enter the engine and causes quicker wear.
Such damages are not covered by the manufacturer
warranty.
AIR FILTER COVER
21