Zanussi ZOU364 Notice D'utilisation page 25

Shelf Support Rails
Removing the shelf support rails
1
Pull the front of the
shelf support rail away
from the side wall.
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
The rounded ends of the shelf support rails must
point to the front!
Oven lamp
Warning! Be careful! There is the risk of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has two panels of glass. You can remove
the oven door and the internal panel of glass to clean it.
The oven door can close if you try to remove the in-
ternal panel of glass before you remove the oven
door.
All manuals and user guides at all-guides.com
2
1
2
Pull the rear shelf sup-
port rail away from the side
wall and remove it.
1
Open the door fully and
hold the two door hinges.
3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove the door
from its seat.
5
Release the locking
system to remove the inter-
nal panel of glass.
2
1
7 Carefully lift (step 1)
and remove (step 2) the
panel of glass.
2
Lift and turn the levers
on the two hinges.
4
Put the door on a soft
cloth on a stable surface.
90°
6
Turn the two fasteners
by 90° and remove them
from their seats.
25