Single Distance Measurement; Continuous Measurement; Care And Maintenance; Cleaning And Drying - Hilti PD 5 Mode D'emploi

All manuals and user guides at all-guides.com
NOTE
If measuring errors occur during continuous measuring,
and continuous measuring mode is canceled by pressing
the "Measure" button again, the last valid measurement will
be displayed.

7.2 Single distance measurement

en 1. Switch on the laser beam by pressing the "Measure" key.
2. Press the "Measure" key once again. Generally, the mea-
sured distance will be completed in less than a second
and shown in the result line on the display.

7.3 Continuous measurement

Press the "Measure" key for 2 seconds to activate this mea-
suring mode.
When doing so, it does not matter whether or not the range
meter is off or the laser beam is switched on or off. The range
meter will always switch to continuous measurement.
During continuous measurement, the distances are updated
in the result line by about 8 to 15 measurements every sec-
ond. This depends on the reflectivity of the target surface.
Continuous measurement is indicated by a Beep. The mea-
suring process is stopped by pressing the "Measure" key
once again. On doing so, the last valid distance measure-
ment shows in the result line on the display.

8. Care and maintenance

8.1 Cleaning and drying

1. Blow dust off the lens.
2. Do not touch the lens with the fingers.
3. Use only a clean, soft cloth for cleaning. If necessary,
moisten the cloth slightly with pure alcohol or a little water.
NOTE Do not use any other liquids as these may damage
the plastic components.
4. The temperature limits for storage of your equipment must
be observed, especially in winter / summer.
8.2 Storage
Remove the tool from its case if it has become wet. The tool,
its carrying case and accessories should be cleaned and
dried (at maximum 40°C). Repack the equipment only once
it is completely dry.
Check the accuracy of the equipment before it is used after
a long period of storage or transportation.
Remove the batteries from the tool before storing it for a
long period. Leaking batteries may damage the tool.
8.3 Transport
Use the original packaging or packaging of equivalent qual-
ity for transporting or shipping your equipment.
CAUTION
Always remove the batteries before shipping the tool.
20