Installation: Forward-Facing; Lower Universal Anchorage System (Luas) Installation - Britax Boulevard CS Guide De L'utilisateur

Installation: Forward-Facing

Lower Universal Anchorage System (LUAS)
Installation
• Figure A illustrates a forward-facing LUAS
installation.
• Verify that your vehicle is equipped with
LUAS anchors. If LUAS anchors are not
available, you must use vehicle belt
installation methods.
WARNING!
• This child seat must not be used forward-
facing for children less than one year of age
OR who weigh less than 9.1 kg (20 lbs).
• This child seat must be in full upright position
when installed forward-facing for children who
weigh more than 15.1 kg (33 lbs).
• Always use the Versa-Tether when the child
seat is installed forward-facing. Check your
vehicle owner's manual for approved tether
anchor locations.
1 If stored, remove the Lower Connector System
from the storage slots under the cover (see
page 30) and route through their adjacent rear-
facing belt slots to the outside of child seat.
2 Press and hold the first LCS adjuster release
button, then pull the LCS strap to full length.
Repeat for the remaining LCS connector.
3 Remove the Versa-Tether from the pouch and
place it up and over the child seat back.
4 Place the child seat forward-facing on the vehicle seat.
TIP:You may need to raise or remove the vehicle head restraint to
achieve best fit of the child seat.
5 Attach one LCS connector to its adjacent vehicle LUAS anchor (Fig. B)
in the upright position (Fig. C).
• An audible click confirms attachment.
• Ensure that the LCS strap is not twisted.
18
All manuals and user guides at all-guides.com
NOTE:
connecting either LCS connector, the LCS strap
may be twisted, or there may be debris in the
LCS connector. Correct either situation before
continuing with the installation process.
be necessary to switch the LCS connectors
as shown on page 29 if ANY of the following
conditions exist:
A
6
7
B
Release Top
Button
8
9
C
10
If an audible click is not heard when
• the LCS connector is not in an upright
position as shown in figure C.
• the LCS strap is twisted.
• An audible click is NOT heard when the
LCS connector and the LUAS anchor are
connected.
Attach the remaining LCS connector to its
adjacent vehicle LUAS anchor (Fig. D) in an
upright position (Fig. C).
Align each LCS strap on the LCS bar with
the "LCS STRAP ON OR ABOVE LINE
FORWARD-FACING" label on each side of
the child seat (Fig. E).
TIP:Gradually tighten each LCS strap and keep
the LCS strap webbing from sliding down
on the LCS bar.
Push the child seat firmly into the vehicle seat
while pulling each LCS strap tight (Fig. F).
Attach the Versa-Tether hook to the
®
vehicle's designated tether anchor for the
chosen seating position. Remove all slack
from the tether to secure. Store excess webbing in the tether pouch.
See pages 25 – 28.
Verify that all connections are secure and that the child seat is stable.
• The child seat is secure when it cannot be moved front- to-back or
side-to-side more than 2.5 cm (1 in.) at the belt path. If the child seat is
not secure, repeat the installation process or use an alternate seating
location.
Installation: Forward-Facing
It may
D
E
F
19