Zanussi ZRG16600WA Notice D'utilisation page 19

Problem
Water flows into the refrigera-
tor.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appli-
ance is too low/too high.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
www.zanussi.com
All manuals and user guides at all-guides.com
Possible cause
Many food products to be fro-
zen were put in at the same
time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
3. Replace the used lamp with a new lamp of
Solution
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
the same power and specifically designed
19