To operate the appliance, proceed as follows:
• turn the Temperature regulator towards
lower settings to obtain the minimum
coldness.
• turn the Temperature regulator towards
higher settings to obtain the maximum
coldness.
A medium setting is generally the
most suitable.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
• room temperature
First use
Cleaning the interior
Before using the appliance for the first time, the
interior and all internal accessories should be
washed with lukewarm water and some neutral
soap to remove the typical smell of a brand-new
product, then dried thoroughly.
Daily use
WARNING!
Refer to Safety chapters.
Movable shelves
The walls of the refrigerator are equipped with a
series of runners so that the shelves can be
positioned as desired.
Positioning the door shelves
To permit storage of food packages of various
sizes, the door shelves can be placed at
different heights.
1. Gradually pull the shelf in the direction of
the arrows until it comes free.
2. Reposition as required.
Hints and tips
Normal operating sounds
The following sounds are normal during
operation:
• A faint gurgling and bubbling sound from
coils sound when refrigerant is pumped.
16
All manuals and user guides at all-guides.com
• how often the lid is opened
• the quantity of food stored
• the location of the appliance.
• A whirring and pulsating sound from the
• A sudden cracking noise from inside
If the ambient temperature is high or
the appliance is fully loaded, and the
appliance is set to the lowest
temperature, it may run continuously
causing frost to form on the rear
wall. In this case the dial must be set
to a higher temperature to allow
automatic defrosting and therefore
reduced energy consumption.
CAUTION!
Do not use detergents or abrasive
powders, as these will damage the
finish.
1
compressor when refrigerant is pumped.
appliance caused by thermic dilatation (a
natural and not dangerous physical
phenomenon).
2
www.zanussi.com