Installation; Water Supply - Conti CC100 Notice Technique

20.

INSTALLATION

20.1. IN CASE OF A STANDBY OF THE MACHINE (STANDBY = 2 MONTHS):
The first thing to do is to test your machine in a lab.
If the machine stop ruming for a long time, you could have scale in some places.
More precisely in small area like the spray nozzle.
20.2. PROTECTIONS
It is necessary to place before the machine:
o A water shutoff valve.
o An electrical protection standard, suitable for voltage and power consumption.

20.3. WATER SUPPLY

Recommended operating pressure from 1.5 MPa to 6 MPa
Water connection pin 3/8"
The water supply pipes must resist to 145 Psi / 10 MPa
20.4. DRAIN
Without pressure.
Spigot at the outlet of the machine and a pipe is supplied with the machine
Ensure a connection that causes no risk of fluid return, and ensure good drainage:
20.5. SUPPLYING VOLTAGE
According to the model:
230V – 50/60Hz Monofase
400V – 50/60Hz Trifase
Edition 05/2015 - CC100 DISPLAY- TECHNICAL DOCUMENTS - page 33
SACOME, CONFIDENTIAL Document,
The drain pipe must be located lower than the machine.
Do not create a bend in the exhaust tube.
it is forbidden to duplicate or communicate this document without previous authorization.